Emerson Rosemount 3051 Reference Manual page 167

Reference Manual
00809-0100-4001, Rev JA
Tagging (3 options available)



Commissioning tag (fieldbus only)
A temporary commissioning tag is attached to all transmitters. The tag indicates the device ID
and allows an area for writing the location.
Optional Rosemount 304, 305, or 306 Integral Manifolds
Factory assembled to 3051C and 3051T transmitters. Refer to the following Product Data Sheet
(document number 00813-0100-4839 for Rosemount 304 and 00813-0100-4733 for
Rosemount 305 and 306) for additional information.
Optional Diaphragm and Sanitary Seals
Refer to Product Data Sheet 00813-0100-4016 or 00813-0201-4016 for additional information.
Output Information
Output range points must be the same unit of measure. Available units of measure include:
(1) Not available on low power or previous versions.
LCD display
M5




M6

Specifications and reference data
Standard SST hardware tag is wired to the transmitter. Tag character height is 0.125 in.
(3,18 mm), 56 characters maximum.
Tag may be permanently stamped on transmitter nameplate upon request, 56
characters maximum.
Tag may be stored in transmitter memory (30 characters maximum). Software tag is
left blank unless specified.
(1)
inH2O
inHg
mmH2O
mmHg
Digital Display, 5-Digit, 2-Line LCD
Direct reading of digital data for higher accuracy
Displays user-defined flow, level, volume, or pressure units
Displays diagnostic messages for local troubleshooting
90-degree rotation capability for easy viewing
Digital Display with 316 Stainless Steel Cover
For use with stainless steel housing option (housing codes J, K, and L)
(1)
inH2O@4 °C
ftH2O
(1)
mmH2O@4 °C
g/cm2
Appendix A: Reference Data
November 2012
psi Pa
bar kPa
mbar torr
kg/cm2 atm
157