Emerson Rosemount 3051 Reference Manual page 106

Section 5: Troubleshooting
November 2012
Message
Looking for a device
Local buttons operator error ON
Mark as read only variable on hotkey
menu?
Module EEPROM write failure ON
No device configuration in configuration
memory
No Device Found
No hotkey menu available for this device.
No pressure updates ON
No offline devices available.
No simulation devices available.
No temperature updates ON
No UPLOAD_VARIABLES in ddl for this
device
No Valid Items
OFF KEY DISABLED
Online device disconnected with unsent
data. RETRY or OK to lose data.
Out of memory for hotkey configuration.
Delete unnecessary items.
Overwrite existing configuration
memory
Press OK...
Restore device value?
ROM checksum error ON
Save data from device to configuration
memory
96
Description
Polling for multidropped devices at addresses 1–15.
Illegal pressure applied during zero or span operation.
Repeat the process after verifying the correct pressures.
Asks whether the user should be allowed to edit the
variable from the hotkey menu if the item being added to
the hotkey menu is a variable.
Message sent to the module from the HART signal failed.
Replace the transmitter.
There is no configuration saved in memory available to
re-configure off-line or transfer to a device.
Poll of address zero fails to find a device, or poll of all
addresses fails to find a device if auto-poll is enabled.
There is no menu named "hotkey" defined in the device
description for this device.
No pressure updates being received from the sensor
module. Verify that the sensor module ribbon cable is
attached correctly. Or replace the transmitter.
There are no device descriptions available to be used to
configure a device offline.
There are no device descriptions available to simulate a
device.
No temperature updates being received from the sensor
module. Verify that the sensor module ribbon cable is
attached correctly. Or replace the transmitter.
There is no menu named "upload_variables" defined in
the device description for this device. This menu is
required for offline configuration.
The selected menu or edit display contains no valid items.
Appears when the user attempts to turn the HC off before
sending modified data or before completing a method.
There is unsent data for a previously connected device.
Press RETRY to send data, or press OK to disconnect and
lose unsent data.
There is no more memory available to store additional
hotkey items. Unnecessary items should be deleted to
make space available.
Requests permission to overwrite existing configuration
either by a device-to-memory transfer or by an offline
configuration. User answers using the softkeys.
Press the OK softkey. This message usually appears after
an error message from the application or as a result of
HART communications.
The edited value that was sent to a device was not
properly implemented. Restoring the device value returns
the variable to its original value.
Checksum of transmitter software has detected a fault.
Replace the electronics board.
Prompts user to press SAVE softkey to initiate a
device-to-memory transfer.
Reference Manual
00809-0100-4001, Rev JA
Troubleshooting