Dhcp/Radvd - Thecus N2800 User Manual

DNS Server 1,2,3
Network Configuration (NIC port)
Link speed
Link status
MAC address
Jumbo Frame Support
IPv4/IPv6
Mode
IP
Netmask/Prefix Length
Gateway
Default gateway
NOTE
WARNING

DHCP/RADVD

From the System Network menu, choose DHCP/RADVD, and the DHCP/RADVD
Configuration screen appears. This screen displays available NIC status. And for
each NIC it can be configured to act as DHCP/RADVD server if it is static IP been
setup.
granted from DHCP server then it will refer to WAN/LAN1 port.
Domain Name Service (DNS) server IP address.
Display associated NIC port link speed.
Display associated NIC port link status.
MAC address of the network interface.
Enable or disable Jumbo Frame Support of associate interface on your
Thecus IP storage.
Click to enable IPv4/IPv6 for TCP/IP. The default is IPv4 enabled.
It can choose a static IP or Dynamic IP.
IP address of associate NIC interface.
Input netmask for IPv4 and Prefix length for IPv6.
Gateway for associate NIC.
It can be choose from drop down list of default gateway been used for the
Thecus IP storage.
• Only use Jumbo Frame settings when operating in a Gigabit environment where
all other clients have Jumbo Frame Setting enabled.
• A correct DNS setting is vital to networks services, such as SMTP and NTP.
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not
be able to connect to your Thecus NAS after Jumbo Frame is turned on.
41