Table of Contents
Advertisement
WARNING
LAN
LAN Configuration
The N7700 supports two Gigabit Ethernet ports for higher service availability. To
configure these ports, choose LAN from the System Network menu, and the LAN
Configuration screen appears. Press Apply to save your changes.
LAN Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
NOTE
DHCP Server Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN port. To configure these ports, choose LAN from the System Network menu.
DHCP Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not
be able to connect to your N7700 after Jumbo Frame is turned on. If this happens, turn off the
N7700. Then, insert USB disk with factory reset utility included and power on the N7700. Till
the system power on complete then it will bring your system settings back to factory default.
Description
Displays the MAC address of the LAN interface.
Enable or disable Jumbo Frame Support on the LAN interface.
Specifies the IP address of the LAN interface.
Specifies the Network Mask of the LAN interface.
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your N7700.
Description
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN interface.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Displayed the DNS server IP address.
40
Advertisement
Table of Contents
