Installing Cables And Connections - Quantum RDX 8000 User Manual

Removable hard disk storage system

Hide thumbs Also See for RDX 8000:

Table of Contents

4.3 Installing cables and connections

DANGER

WARNING

To connect the power cord to the unit:

1. Plug the power cord into the power connector (AC connector) on the rear panel of the power supply; see section

Rear panel,

2. Plug the power cord into an appropriate electrical outlet.

To connect the network cable:

The connection to the Ethernet network is via an industry stand RJ45 copper interface on the rear panel of the unit; see

section Rear panel.

1. Insert the Ethernet cable into the Ethernet port #1 of the unit. When the plug is in the full seated position, a

positive click should be heard.

RDX 8000 User Guide

High voltage

Risk of electric shock

• Do not remove cover. No user-serviceable parts are inside.

• Refer servicing to qualified service personnel.

Usage of unapproved power cords

Risk of personal injury

Risk of damage to devices

Before connecting a power cord to the unit:

• Ensure that the power cord meets individual country specific safety requirements.

• Use a sufficient conductor amp capacity to avoid overheating the unit.

The manufacturer disclaims all liability in the event a non-manufacturer approved

power cord is used.

Table of Contents