Cru Replacement; Power Supply; Removing A Power Supply; Installing A Power Supply - Quantum RDX 8000 User Manual

Removable hard disk storage system

Hide thumbs Also See for RDX 8000:

Table of Contents

2. CRU replacement

The power supply is a CRU (Customer Replaceable Unit). The power supply is located on the rear side of the unit and is

fixed with two thumb screws. The power supply is capable to power up to 8 cartridges simultaneously while supporting

other unit electronics (controller, LED`s, OCP, motors).

For technical specification, see section

1. Power down the unit by pressing the power button on the front panel.

2. Locate the power supply on left side on the rear panel of the RDX 8000 unit, shown in section

layout" on page

10.

3. Remove the power cord on the rear panel of the unit.

4. Loosen the two thumbscrews located on the rear of the power supply using a #3 Phillips screwdriver or your

fingers.

5. Pull the power supply straight out of the unit.

6. To store or ship the removed power supply, repackage it in the original or replacement device packaging materi-

als.

1. Locate the power supply bay on left side on the rear panel of the RDX 8000 unit, shown in section

layout" on page

10.

2. Before installing the power supply, inspect the connectors on the power supply. Ensure that the connectors are

intact, free of any foreign objects, and have no cracks or deformed or bent contacts.

3. Insert the power supply on the alignment rails and push the power supply into the power supply bay until it seats

itself against the back of the unit.

Figure 54 — Installing a power supply

4. Tighten the two thumbscrews using a #3 Phillips screwdriver or your fingers to secure the power supply to the

unit.

RDX 8000 User Guide

"1. Product specification" on page

75.

"3.1 Rear panel

Table of Contents