Lighting; General Information; Lighting Control - Ford Transit Connect 2013 Owner's Manual

GENERAL INFORMATION

Condensation in Lamp Assemblies
Exterior lamps have vents to
accommodate normal changes in air
pressure.
Condensation can be a natural by-product
of this design. When moist air enters the
lamp assembly through the vents, there is
a possibility that condensation can occur
when the temperature is cold. When
normal condensation occurs, a fine mist
can form on the interior of the lens. The
fine mist eventually clears and exits
through the vents during normal operation.
Clearing time may take as long as 48 hours
under dry weather conditions.
Examples of acceptable condensation are:
• The presence of a fine mist (no streaks,
drip marks or large droplets).
• A fine mist covers less than 50% of the
lens.
Examples of unacceptable condensation
are:
• A water puddle inside the lamp.
• Streaks, drip marks or large droplets
present on the interior of the lens.
If you see any unacceptable condensation,
have your vehicle checked by an authorized
dealer.
Transit Connect () Long Wheelbase Double Cab in Van/Long Wheelbase Van/Short Wheelbase Double Cab in Van/Short Wheelbase Van, Short Wheelbase Kombi/Kombi BaseLong Wheelb

Lighting

LIGHTING CONTROL

Lighting Control Positions
A Off
B Parking lamps, instrument panel
lamps, license plate lamps and
tail lamps
C Headlamps
Parking Lamps
Note: Prolonged use of the parking lamps
will cause the battery to run out of charge.
Switch the ignition off.
Both Sides
Set the lighting control to position B.
47