Cold Weather Precautions; Driving Through Water; Floor Mats - Ford Transit Connect 2013 Owner's Manual

Hide thumbs Also See for Transit Connect 2013:
Table of Contents

Advertisement

1.
Reduce your speed gradually and stop
your vehicle as soon as it is safe to do
so.
2. Switch the engine off immediately to
prevent severe engine damage.
3. Wait for the engine to cool down.
4. Check the coolant level. See Engine
Coolant Check (page 167).
5. Have your vehicle checked by an
authorized dealer as soon as possible.
COLD WEATHER
PRECAUTIONS
The functional operation of some
components and systems can be affected
at temperatures below -13°F (-25°C).

DRIVING THROUGH WATER

WARNINGS
Drive through water in an emergency
only and not as part of normal
driving.
Engine damage can occur if water
enters the air filter.
In an emergency, you can drive your vehicle
through water to a maximum depth of 8
inches (200 millimeters) and at a
maximum speed of 6 mph (10 km/h). You
must take extra care when driving through
flowing water.
When driving in water, maintain a low
speed and do not stop your vehicle. After
driving through water and as soon as it is
safe to do so:
Depress the brake pedal lightly to
check that the brakes are functioning
correctly.
Check that the horn works.
Transit Connect () Long Wheelbase Double Cab in Van/Long Wheelbase Van/Short Wheelbase Double Cab in Van/Short Wheelbase Van, Short Wheelbase Kombi/Kombi BaseLong Wheelbase Ko
Driving Hints
Check that your vehicle's lamps are
fully operational.
Check the power assistance
of the steering system.

FLOOR MATS

Always use floor mats that are
designed to fit the foot well of your
vehicle, leaving the pedal area
unobstructed, and which can be firmly
secured to retention posts so that they
cannot slip out of position and interfere
with the pedals or impair safe operation of
your vehicle in other ways.
Incorrectly fitted floor mats can
cause the accelerator pedal to
become stuck in the open position.
This can cause loss of vehicle control.
Always correctly install the floor
mats to the retention posts so that
they cannot slip out of position or
obstruct pedal operation.
Do not place unsecured floor mats
or any other covering in the foot well.
Do not place additional floor mats
or any other covering on top of the
original floor mats. This will reduce
the pedal clearance and interfere with the
pedal operation.
142
WARNINGS

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents