Table of Contents
Advertisement
Initialize and Configure
6. If the volume is not intended to consume the remaining capacity shown in the
enter the intended capacity for the volume being created.
If no hosts have been created, no entries appear in the
umes during the host-creation process (see "Configuring Hosts" on page 60).
7. Enter volume information in the optional
including special characters except those listed in "Command Line Interface (CLI)" on page 45.
8. To clear volume data entered since the last
The view restores the most recently saved settings.
9. To create the volume as defined, click
The
Volume Summary
"View, Modify LUNs" on page 85 for more information about LUNs.
10. To create additional volumes, repeat Step 1 through Step 9 in this procedure until all desired volumes have
been created.
Figure 41. Volume Summary
Xiotech—Proprietary
Comment
SUBMIT
.
SUBMIT
appears (see Figure 41), showing all existing volumes with their host mappings. See
160337-000 Rev D, 30 September, 2013
list. Hosts can be mapped to vol-
Available Hosts
field that accepts up to sixty alphanumeric characters,
, click
.
RESET
ISE User Guide
field,
Capacity in Gigabytes
Page 59
Advertisement
Table of Contents
