Adding A Managed Reliability Controller; Web-Mgt - X-IO ISE-2 Series User Manual

ISE User Guide
Command Options
--status
--mrc1
--mrc2
--force
remove
--datapac1
--datapac2
--erase
remove --mrc1 --force
remove --datapac2 --erase
Table 44: Remove Command—CLI

Adding a Managed Reliability Controller

When a new MRC is installed into the ISE, it must be added to the configuration before the system can begin
using it. The new MRC is automatically configured with the parameters effective on the remaining MRC. The
following sections detail the procedure to add an MRC to the system configuration using the Web-Mgt and the
CLI. The and
Add Remove
Upgrade procedure is in progress.
X-IO
Contact Customer Support for assistance with physically adding an MRC.
Note.

Web-Mgt

To add an MRC to the ISE configuration using the Web-Mgt, follow these steps:
1. Select >>
Maintenance
The Add MRC view appears.
2. Select the radio button of the MRC being added.
The status of each MRC is displayed to help identify the MRC to be added. Table 43 on page 137
describes the various FRU states for adding and removing FRUs.
3. Click and then click
SUBMIT
The Add MRC1 or MRC2 view appears with a moving logo to indicate activity. The view refreshes itself
automatically every few seconds. The Add process can take several minutes to complete.
If the browser session is accessing the MRC being added, the connection may be terminated
Note.
by the Add MRC function. Reactivate the browser connection to the MRC, if necessary, by waiting five
seconds and then clicking the
When the configuration process is complete, the progress bar shows 100% and the message Add MRC
Complete appears.
4. Click and the Add MRC view appears, showing that both MRCs are present and operational.
CONTINUE
Page 138
Comment
Shows removal status of both DataPacs and MRCs.
Prepares MRC1 or 2 for removal from the system.
Use with --mrc1 or --mrc2 options to override rejection of the remove
command.
Prepares DataPac 1 or 2 for removal from the system.
Use with --datapac1 or --datapac2 options to securely erase the DataPac
before removal.
Examples:
procedure is blocked by the ISE system while an Add, Remove, or MRC Firmware
.
add mrc
on the confirmation dialog box that appears.
OK
button. The browser returns to the Add MRC1 or MRC2 view.
Refresh
160337-000 Rev D, 30 September, 2013
Maintenance
Xiotech—Proprietary