Table of Contents
Advertisement
ISE User Guide
Address
The Address is an optional user-defined address for an ISE, defining a physical address, building, or any
address string. The address is any alphanumeric string of up to sixty characters. Embedded blanks and special
characters (excepting "Reserved Characters" on page 29) are permitted.
Web-Mgt: To view or set the Address from the Web-Mgt, select the System Information Settings view (
>>
).
system info
CLI: To display the Address from the CLI, use the show ise command. To set the Address from the CLI, use
the configure --address=<ise_address> command (see Figure 13 on page 49). If the address is to
contain embedded blanks, enclose the character string in quotation marks as shown in the following example:
configure --address=<"ISE Address">
Location
The Location is an optional user-defined location for an ISE, such as a data center, room number, rack
number, rack position, or any other type of locator. The location is any alphanumeric string of up to sixty
characters. Embedded blanks and special characters (excepting "Reserved Characters" on page 29) are
permitted.
Web-Mgt: To view or set the Location from the Web-Mgt, select the
>>
).
system info
CLI: To display the Location from the CLI, use the show ise command. To set the Location from the CLI, use
the configure --location=<ise_location> command (see Figure 13 on page 49). If the location is to
contain embedded blanks, enclose the character string in quotation marks as shown in the following example:
configure --location=<"ISE location">
Contact Name
The Contact Name is an optional user-defined name for a person associated with this ISE, such as a storage
manager, network administrator, or other associated person. The contact name is any alphanumeric string of
up to sixty alphanumeric characters. Embedded blanks and special characters (excepting "Reserved
Characters" on page 29) are permitted.
Web-Mgt: To view or set the Contact Name from the Web-Mgt, select the System Information Settings view
(
>>
).
System
system info
CLI: To display the Contact Name from the CLI, use the show ise command. To set the Contact Name from
the CLI, use the configure --contact=<contact_name> command (see Figure 13 on page 49). If the
contact name is to contain embedded blanks, enclose the character string in quotation marks as shown in the
following example:
configure --contact=<"contact name">
Contact Phone
The Contact Phone is an optional user-supplied phone number for the contact person (see "Contact Name" on
page 50). The contact phone is any alphanumeric string of up to sixteen characters. Embedded blanks and
special characters (excepting "Reserved Characters" on page 29) are permitted.
Web-Mgt: To view or set the Contact Phone from the Web-Mgt, select the System Information Settings view
(
>>
).
System
system info
Page 50
160337-000 Rev D, 30 September, 2013
Initialize and Configure
System Information Settings
Xiotech—Proprietary
System
view (
System
Advertisement
Table of Contents
