Pppoe - Draytek VIGOR3300V+ User Manual

WAN Interface
DHCP Server IP Address
Next, click IP Routing tab to set routing path for each WAN interface if required.
When you finished the above settings, please click Finish. A system reboot page will appear.
Click Apply to activate the DHCP mode configuration.

2.2.3 PPPoE

PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE
connection for accessing the Internet. Your service provider will provide you information
about user name, password, and authentication mode.
If your ISP provides you the PPPoE (Point-to-Point Protocol over Ethernet) connection,
please select PPPoE for this router to get the following page. Enter the username and
password provided by your ISP on the web page.
Choose the WAN interface for such connection.
Type an IP address for the DHCP server.
18
Vigor3300V+ Series User's Guide