Table of Contents
Advertisement
User Name
Password
Authentication
Service Name
After setting up the PPPoE, click Next to setup the LAN interface continuously.
IP Address
Subnet Mask
Status
Start IP
End IP
Vigor3300V+ Series User's Guide
Type a specific valid user name provided by the ISP.
Type a valid password provided by the ISP.
Select PAP, CHAP, MS-CHAP or MS-CHAP-V2 protocol
for PPP authentication. The default value is PAP.
Type a service name required from ISP service.
Type an IP address for the LAN interface.
Type the subnet mask for the LAN interface.
Click Enable to use DHCP server; click Disable to close
DHCP server; click Relay Agent to activate relay agent
function.
Type the start IP address of the IP pool that DHCP server can
use for clients in LAN.
Type the end IP address of the IP pool that DHCP sever can
use for clients in LAN.
19
Advertisement
Table of Contents
