Advertisement
Wiring the Power Inputs
Use the following procedure to wire the power inputs. The working voltage is
48VDC or -48VDC.
1. Insert the positive and negative wires into the V+ and V- contact on the terminal
block connector.
2. Tighten the wire-clamp screws to prevent the DC wires from becoming loose.
PWR1
1A@24V
-
+
FAULT
Power 1
Wire: 12 to 24 AWG
Wiring
Wiring the Relay Output
the
The relay output alarm contacts are in the middle of the terminal block connector.
PWR1
1A@24V
-
+
FAULT
Relay Output Alarm Contacts
1A@24V
PWR2
+
-
Power 2
Relay
Output
PWR2
+
-
Advertisement
