IDTECK Star iCON100 Quick Installation Manual page 4

※
iCON100/iCON100-SR QUICK INSTALLATION GUIDE
These switches are to set board ID and baud rate to communicate with PC. (#1~#5 DIP switches for board ID,
#6~#8 DIP switches for baud rate)
○
Initialization Switches
4
These switches are to initialize user data in the memory. To be default setting by Initialization, press the two
switches simultaneously then keep pressing more than 2 seconds to initialize properly.
○
RJ45 LAN port
5
This port is to connect RJ45 LAN cable for communicating with PC.
○
6 LED
This is to show the status of LAN communication
○
RL #1 ~ #2 Ports
7
These ports are connected to control signal line of buzzer and LED of the reader. It is used to show operating
status for the reader during operating RL#1 and RL#2.
○
Input #5 Port
8
This is the Input #5 port. LED is turned on when Input signal is perceived.
○
Input #4 Port
9
This is the Input #4 port. LED is turned on when Input signal is perceived.
○
Input #3 Port
10
This is the Input #3 port. LED is turned on when Input signal is perceived,
○
Input #2 Port
11
This is the Input #2 port. LED is turned on when Input signal is perceived.
○
Input #1 Port
12
This is the Input #1 port. LED is turned on when Input signal is perceived.
○
13 MCU Module connecter
It's the terminal for MCU module connection.
○
14 IIM7100A Connector
It's the terminal for IIM7100A(Optional) connection.
○
15 Reader #2 Port
This is the port to connect reader #2.
○
16 Reader #1 Port
This is the port to connect reader #1.
○
17 Buzzer
This is an internal buzzer, which makes beep sounds when the keypad is pressed from the optional keypad.
○
18 LCD Display Connector
This connector is to connect optional LCD display. It can be used with optional keypad for manual setup and
to check the device's set-up status.
○
19 Keypad Connector
This connector is to connect optional keypad. It can be used with optional LCD display for manual setup and
to check the device's set-up status.
○
20 Main Power Port
This is main power port and iCON100 is working at DC12V, maximum of 200mA current. (It is applied only
when door lock devices, alarms, sensors and reader is not connected.)
4