IDTECK Star iCON100 Quick Installation Manual page 13

※
iCON100/iCON100-SR QUICK INSTALLATION GUIDE
5.3.3 Baud Rate Setting
Baud rate is the speed rate during communication with host PC. The 3 DIP switches are assigned for baud
rate setting on the upper left side of the iCON100 board. You can select one of 4800bps, 9600bps, 19200bps,
38400bps, 57600bps and 115200bps.You have to set applicable baud rate according to communication
environment, and the connected devices on one loop must have the same baud rate. If DIP switch turns from
'ON' to 'OFF' or 'OFF' to 'ON', buzzer is generated. Also under TCP/IP communication, the baud rate has to
be matched with TCP/IP module.
 Caution
Baud rate must be the same as the values set by application software (STARWATCH DUAL PRO I, II
and STARWATCH STANDARD) and the baud rate of all products on the same loop must be same.
If you use ver. 6.0 and lower with ver. A1.0 and higher together, set the baud rate to 9600bps only.
When you only use ver. A.1.0 and higher, you can set other baud rate including 9600bps.
If you set high baud rate in bad environment for communication, communication may not properly
operate. In this case, let baud rate lower.
Switches for Baud Rate
Figure: Position of Baud Rate Setting Switches
(Default)
Baud Rate
Figure: Setting Example
5.4 Wiring
5.4.1 Power
Connect (+) wire of DC 12V power to +12V terminal
Connect GND (-) wire of DC 12V power to GND terminal
5.4.2 Input Connections
 Exit Button Connection (Input #1)
- Connect one wire from an Exit Button to Input #1
- Connect the other wire from the Exit Button to the GND
 Door Contact Sensor Connection (Input #2)
13