Dismantling And Rinsing The Cappuccino Frother; Inserting The Filter - Jura J6 Instructions For Use Manual

5 Maintenance
Dismantling and rinsing
the cappuccino frother

Inserting the filter

36
To make sure the cappuccino frother works properly, and in the
interests of hygiene, it must be dismantled and rinsed daily if you
have been preparing milk.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully pull the cappuccino frother down and off.
T Dismantle the cappuccino frother into its individual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 8.5 oz (250 ml) cold water and 1 capful of JURA
milk system cleaner. Then rinse the parts thoroughly.
T Reassemble the cappuccino frother.
E Ensure that all individual parts are correctly and firmly con-
nected to ensure correct operation of the cappuccino frother.
T Firmly attach the frother to the connector.
Your J6 no longer has to be descaled if you are using the CLEARYL
Smart filter cartridge. If you did not insert the filter cartridge the first
time you used the machine, you can do this now as follows.
T Place a receptacle under the hot-water spout.
T Remove and empty the water tank.
T Open the filter holder.
T Fit the filter cartridge extension supplied on top of a CLEARYL
Smart filter cartridge .
T Insert the filter cartridge with its extension into the water
tank.
T Close the filter holder. It will click into place audibly.
T Fill the water tank with fresh, cold water and reinsert the
tank.
E The machine automatically detects that you have just inserted
the filter cartridge.
'Filter operation'
'Filter is being
spout.
/ 'Saved'
rinsed', water flows out of the hot-water