Permanently Setting The Amount Of Water For The Cup Size; Adjusting The Grinder - Jura J6 Instructions For Use Manual

Permanently setting the
amount of water for the
cup size

Adjusting the grinder

Preparation stops automatically. Your J6 is once more ready
for use.
It is easy to permanently adjust the amount of water for all single
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
T Place a cup under the coffee spout.
T Press and hold the
Press button'
T Release the
Preparation starts and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
set amount of water for one coffee is permanently stored.
Your J6 is once more ready for use.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amounts for all single
products in programming mode (see Chapter 4 'Permanent
settings in programming mode – Adjusting the product
settings').
You can adjust the grinder to suit the degree of roast of your coffee.
If you adjust the consistency of grind when the grinder is not
NOTICE
operating, the grinder adjustment switch could be damaged.
T Only adjust the consistency of grind when the grinder is
running.
The consistency of grind is correct if the coffee flows regularly from
the coffee spout. In addition a fine, thick crema forms.
Example: Proceed as follows to change the consistency of grind
during the preparation of an espresso.
'Coffee' button until
appears.
'Coffee' button.
'Saved' appears briefly on the display. The
2 Preparation
'Enough coffee?
19