Dismantling And Rinsing The Cappuccino Frother - Jura J6 Quick Reference Manual

J6/J600 – Quick Reference Guide
Dismantling and rinsing
the cappuccino frother
4
T During the first brief interruption, set the setting wheel of
the cappuccino frother to the Milk Foam position 5.
'Water for cleaning milk system'
T Rinse the container thoroughly and fill the front part with
fresh water up to the upper mark.
T Place this under the cappuccino frother and reconnect the
milk pipe to the container.
T Press the 'Next'
'Milk system is being cleaned'
frother and the milk pipe are rinsed with fresh water.
The start screen is displayed.
To make sure the cappuccino frother works properly, and in the inte-
rests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully pull the cappuccino frother down and off.
T Dismantle the cappuccino frother into its individual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 250 ml cold water and 1 capful of JURA milk
system cleaner. Then rinse the parts thoroughly.
T Reassemble the cappuccino frother.
E Ensure that all individual parts are correctly and firmly con-
nected to ensure correct operation of the cappuccino frother.
T Firmly attach the frother to the connector.
button.
appears and the cappuccino