Menu C; Setup - KROHNE OPTISONIC 3400 Handbook

OPTISONIC 3400
B3 Information
B3 Information
B3.1 Status Log
B3.2 Status Details
B3.3 C Number
B3.4 Process input
B3.4.1 Sensor CPU
B3.4.2 Sensor DSP
B3.4.3 Sensor Driver
B3.5 SW. REV. MS
B3.6 SW. REV. UIS
B3.7 "Bus interface"
B3.7.0 Profibus
B3.7.0 Foundation Field
Bus
B3.7.0 Modbus
B3.8 Electronic Revision
B3.9 Change Log

6.3.3 Menu C; setup

Function
C1 Setup
C1.0 Process Input
C1.1 Meter size
C1.2 Calibration
C1.2.1 Zero Calibration
C1.2.2 GK
C1.3 Filters
C1.3.1 Limitation
C1.3.2 Flow Direction
C1.3.3 Time constant
C1.3.4 Low flow cutoff
C1.4 Plausibility
C1.4.1 Error limit
C1.4.2 Counter decrease
C1.4.3 Counter limit
05/2016 - 4002037705 - HB OPTISONIC 3400 R05 en
Log for errors and warnings
Present errors and warnings in NE107 groups
Displays C number of the installed electronics
Displays information of the sensor electronics PCB
Displays information of the sensor CPU software
Displays information of the sensor DSP software
Displays information of the sensor driver hardware
Displays information of Main Software
Displays information of User Interface
Only appears with Profibus, Modbus and FF
Displays information of the Profibus interface
Displays information of the Foundation Fieldbus interface
Displays information of the Modbus interface
Displays information of the Electronics Revision
The last changes of parameters are listed in this menu point, together with
date and time. As a reference a CRC (checksum) over all parameters is used.
This reference can be used by the customer for their documentation. The
preview shows the actual CRC.
Settings / descriptions
Sets the pipe diameter
Zero Offset
Direct setting of zero offset
Sets the meter factor
Limits for the flow speed
Set polarity of flow direction
Sets timing constant of the sensor
Sets the low flow cutoff
Error filtering
sets the error limit in percentage of the measured value: exceeding values
will be discarded and plausibility counter increased
Sets the decrease of the plausibility counter when the measurement is
within limits
Sets the limit for the plausibility counter for which measurements will not
be discarded
www.krohne.com
OPERATION
6
65