Menu Item Setup (Firmware Version - Basic) - KROHNE OPTISWIRL 4070 Handbook

OPTISWIRL 4070

6.5.6 Menu item Setup (firmware version - basic)

Basic version:
Level Designation
3.1
3.1.1 Error message
→
3.1.2 Cycle.Disp.
→
3.1.3 Code 1
→
3.2
3.2.1 4-20mA off
→
3.2.5 Function P
→
3.2.7 Totalizer
→
3.2.8 Tot. Conf.
→
(available if Maes.Inst =
Volume, see menu item
1.1.3)
(available if Maes.Inst =
Norm. Vol., see menu
item 1.1.3)
04/2016 - 4000150609 - MA OPTISWIRL 4070C R10 en
Selection / entry
Yes ↑...
No ↑...^
Yes ↑...
No ↑...^
Yes ↑...
No ↑...^
4-20mA ↑...
4-20/22E ↑...
4-20/3.55E ↑...^
Yes ↑...
No ↑...^
Tot. on ↑...
Tot. off ↑...^
3
m
Unit ↑...^
0000000000
3
↑...↑...↑...^
m
Reset Yes /
Reset No ↑...^
Disp. off /
Disp. on ↑...^
3
m norm
Unit ↑...^
0000000000
3
norm ↑...↑...↑...^
m
Reset Yes /
Reset No ↑...^
Disp. off /
Disp. on ↑...^
www.krohne.com
Explanation
Set display
Display error
Shows error messages in measuring mode in plain text
alternating with the measured values
Flashing cursor in the top left corner of the display
indicates errors.
Display measured values
Cyclically display measured values in measuring mode
(6 s intervals)
Do not display measured values cyclically
Set security query 1 (menu)
Activate access code:
→→→↑↑↑^^^
Deactivate access code
I/O Settings
Current output 4-20 mA and error current
Current output 4-20 mA
Current output 4-20 mA or error current 22 mA
Current output 4-20 mA or error current 3.55 mA
Pulse Output
Activate pulse output
Deactivate pulse output
Totalizer
Start Totalizer
Stop totalizer (value is held)
Configure totalizer
Select totalizer unit for volume flow measurement
Enter preset totalizer value
Reset counter /
Do not reset totalizer/
Display totalizer /
Do not display totalizer
Select totalizer unit for standard volume flow
measurement
Enter preset totalizer value
Reset counter /
Do not reset totalizer/
Display totalizer /
Do not display totalizer
OPERATION
6
55