Commissioning
netTAP NT 151RERE | RealTime Ethernet gateway
DOC150802UM01EN | Revision 1 | English | 201607 | Released | Public
Note that the SD card must be FAT formatted, otherwise it will not be
recognized by the device. Detailed instructions on how to transfer
configuration data into another netTAP device by SD memory card can be
found in chapter Using SD memory card to copy configuration data into
spare netTAP devices [} page 47].
Resetting the netTAP to its factory settings by using an SD memory card
(e. g. in case of a defective firmware) is described in the subsequent
chapter.
35/81
© Hilscher 2016