Using SD memory card to copy configuration data into spare netTAP devices
2. Open existing netTAP project or create a new project.
3. Open the netTAP configuration window (i. e. the netTAP DTM).
netTAP NT 151RERE | RealTime Ethernet gateway
DOC150802UM01EN | Revision 1 | English | 201607 | Released | Public
Note:
You can use your already existing configuration project to establish
a USB connection between SYCON.net and the netTAP device,
and to open the Memory Card Management dialog. If you don't
have access to the old configuration project file, you can create a
provisional new project, consisting only of the netTAP symbol, and
use this makeshift project to establish the USB connection.
Ø In the menu, choose File > Open...to open an existing netTAP project.
OR
Ø In the Vendor tab of the Device Catalog (right window), open folder
Hilscher GmbH > Gateway StandAlone Slave. Then select NT 151
RERE device and drag & drop it onto the bus configuration line in the
middle window.
Figure 23: SYCON.net_SD_Karte1
Ø Doubleclick the netTAP symbol in the bus configuration line, or select
the netTAP symbol and choose Configuration > Gateway from the
context menu (to open context menu, rightclick on the netTAP symbol).
49/81
© Hilscher 2016