Setting Tab Configuration - Mitsubishi Electric AE-200A Instruction Book

5-3. Setting tab configuration

Settings screens that are selected in the main tab and sub tab are as follows, and the items that can be set on
each settings screen are as below.
Main tab
System Settings
Group Settings
BACnet Settings
WT07921X01
Sub tab
Sets IP address information for AE-200 LAN1 (for air conditioning)
Basic System
and LAN2 (for BACnet
conditioning unit to connect.
This also displays the AE-200 serial number, AE-200 program version, and
the BACnet
Displays group settings for the air conditioning unit, remote controller, and
Group
system controller.
Group information cannot be changed from the BACnet
Tool. Configure group settings from the AE-200 Initial Setting Tool.
Refer to the Instruction Book (BACnet
method.
BACnet
Sets BACnet
I-Am transmission periods; air conditioning unit settings including dry mode
usage Y/N, fan speed Mid1/Mid2 usage Y/N, and operation mode status
automatic display Y/N.
Network and
Registers notification destination devices for COV and EVENT notifications.
Device
Registers device number, process ID, and notification type (with
COV Notification
confirmation, without confirmation) for COV Notification destinations.
Registers device number, process ID, and notification type (with
Event Notification
confirmation, without confirmation) for Event Notification destinations.
Selects the object to use, the requirement for COV/Event Notification and
Object
the notification destination, and sets the Event Notification (Event_Enable,
Notify_Type).
Other
Set the notification destination at reset.
Used when using the Settings Tool to cancel an AE-200 emergency stop
ForcedOff Reset
originating from the central monitoring device (BACnet
required.
Setting items
®
connection), and time synchronization for air
®
program version.
®
settings including AE-200 device numbers, APDU settings,
19
®
Setting
®
Setting Tool) for the setting
®
). Settings not