Preventive Maintenance; Manual Override - Lippert Components Level-Up Manual

Preventive Maintenance

1 . Remove dirt and road debris from jacks and stabilizer
struts (if equipped) as needed .
2 . If jacks are down for extended periods, it is recommended
to spray exposed leveling jack tubes with a spray lubricant
every 3 months for protection . If the coach is located in
a salty environment, it is recommended to spray the rods
every month .
Ensure the coach is supported at both the front and rear
with jack stands before performing any troubleshooting
or service to the unit. Failure to do so may result in death
or personal injury.

Manual Override

The LCI Level-Up® Automatic Leveling System can be manually
operated with an electric drill . In the event of electrical or system
failure, this manual method of extending and retracting the jacks
can be used . See the instructions below .
NOTE: Unhook the power unit motor from the power source prior to
attempting the manual override procedure .
1 . Locate the valves that are paired with the landing gear or leveling
jack to be manually overridden .
A . Landing Gear - Valve located on the lead landing gear (Fig . 34) .
B . Leveling Jacks - Valve located on valve block (Fig . 35) .
2 . Using a 5/32" hex wrench, open the valve by turning the manual
override set screw clockwise (Fig . 36) .
3 . Remove protective label from power unit motor to reveal the
manual override coupler (Fig . 37) .
4 . Using an electric drill with a 1/4" hex bit, insert the hex bit into
the manual override coupler to manually operate the Level-Up
system (Fig . 38) .
www.lippertcomponents.com (574) 537-8900
Level-Up®
Aftermarket Manual
A . Run the drill forward (clockwise) to retract the landing gear
or leveling jack .
B . Run the drill in reverse (counterclockwise) to extend the
landing gear or leveling jack .
5 . Be sure to turn the manual override set screw on the valve
back to the counterclockwise position after extending or
retracting the landing gear or leveling jack (Fig . 39) .
Fig.34
Fig.36
Fig.38
16
Rev: 09.15 - Level-Up® Aftermarket Manual
Fig.35
Fig.37
Fig.39