Lippert Components Level-Up Manual page 10

3 . Cut a hole in the wall of the compartment 3
2 3 / " high so the top and bottom horizontal cuts are
4
parallel to the floor of the compartment (Fig . 22) .
Compartment Wall
3 3 /
8
4 . Feed the touch pad harness through this hole and
run it to the compartment where the controller is mounted .
Plug the harness into the appropriate connector on the
controller .
5 . Insert the touch pad bezel into the cutout and attach it with
four #8x1" wood screws with sufficient length to thread into
the compartment wall (Fig . 23) .
Touch Pad
Bezel
www.lippertcomponents.com
3 / " wide by
8
Fig.22
2 3 / "
4
"
Fig.23
Wood Screw
(574) 537-8900
Level-Up®
Aftermarket Manual
6 . Plug the touch pad harness into the connector on the back
of the touch pad face plate and snap the face plate into the
bezel (Figs . 24 and 25) .
Touch Pad
Face Plate
7 . The last harness to connect is the one that powers and controls
The system . One end will have two connectors that plug into
the controller, a 9-pin and a 6-pin, and the other will have eight
color coded wires .
8 . Connect the 9-pin and 6-pin connectors to the proper ports on
the controller .
10
Rev: 09.15 - Level-Up® Aftermarket Manual
Fig.24
Fig.25