Centrifugal Oil Filter - Cleaning And Filter-Sleeve Replacement - MTU 16V4000M73 Operating Instructions Manual

8.16.20 Centrifugal oil filter – Cleaning and filter-sleeve replacement
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Torque wrench, 4–20 Nm
Torque wrench, 10–60 Nm
Cold cleaner (Hakutex 60)
Filter sleeve
Sealing ring
WARNING
Oil is hot.
Oil can contain residue/substances which are harmful to health.
Risk of injury and poisoning!
• Allow the product to cool to below 50 °C before beginning work.
• Wear protective clothing, protective gloves and goggles/safety mask.
• Avoid contact with skin.
• Do not inhale oil vapor.
WARNING
Compressed air gun ejects a jet of pressurized air.
Risk of injury to eyes and damage to hearing, risk of rupturing internal organs!
• Never direct air jet at people.
• Always wear safety goggles/face mask and ear defenders.
Centrifugal oil filter – Cleaning
and filter-sleeve replacement
1. Remove clamp (17).
2. Release cover nut (2) and take off cover (1).
3. Carefully lift rotor (14), allow oil to drain and
remove from housing.
4. Holding the rotor (14) firmly, release rotor
cover nut (3).
5. Take off rotor cover (3).
6. Remove filter sleeve (6).
7. Measure thickness of oil residues on filter
sleeve (6).
Result: Shorten maintenance interval if the oil resi-
dues exceed the maximum thickness of
45 mm.
8. Disassemble rotor tube (7), conical disk (8)
and rotor base (13).
(→ Spare Parts Catalog)
(→ Spare Parts Catalog)
MS150123/01E 2017-05 | Oil Filtration / Cooling | 239
Part No. Qty.
F30044239 1
F30452769 1
X00056750 1