MTU 16V4000M73 Operating Instructions Manual page 108

357 – AL Open Load Cylinder B7
Cause
Disruption fault in injector wiring
cylinder B7.
358 – AL Open Load Cylinder B8
Cause
Disruption fault in injector wiring
cylinder B8.
359 – AL Open Load Cylinder B9
Cause
Disruption fault in injector wiring
cylinder B9.
360 – AL Open Load Cylinder B10
Cause
Disruption fault in injector wiring
cylinder B10.
361 – AL Power Stage Low
Cause
The output stage voltage to
control the injectors is too low.
362 – AL Power Stage High
Cause
The output stage voltage to
control the injectors is too high.
363 – AL Stop Power Stage
Cause
The output stage voltage to
control the injectors is too low.
Engine stop
365 – AL Stop MV-Wiring Ground
Cause
Short circuit of positive or
negative terminal of one or more
injectors to ground.
108 | Troubleshooting | MS150123/01E 2017-05
Corrective action
1. Check wiring of affected injector (→ Page 268).
2. Contact Service.
Corrective action
1. Check wiring of affected injector (→ Page 268).
2. Contact Service.
Corrective action
1. Check wiring of affected injector (→ Page 268).
2. Contact Service.
Corrective action
1. Check wiring of affected injector (→ Page 268).
2. Contact Service.
Corrective action
1. Check power supply (plant).
2. Contact Service.
Corrective action
1. Check power supply (plant).
2. Contact Service.
Corrective action
1. Check power supply (plant).
2. Contact Service.
Corrective action
1. Check cabling (→ Page 268).
2. Restart engine.
3. Contact Service.