Centrifugal Oil Filter - Cleaning And Filter-Sleeve Replacement - MTU 20 V 4000 G23 Technical Publication

Task Description
6.13.2 Centrifugal oil filter – Cleaning and filter-sleeve replacement
Preconditions
• Engine is stopped and starting disabled.
Special tools
Designation / Use
Torque wrench 6-50 Nm
Material
Designation / Use
Cleaner Hakutex 60
Spare parts
Designation / Use
Filter sleeve
Sealing ring
Sealing ring
Hot oil.
Oil can contain combustion residues which are harmful to health.
WARNING
Risk of injury and poisoning!
Compressed air.
Risk of injury!
WARNING
Centrifugal oil filter – Cleaning and filter-sleeve
replacement
1. Remove clamp (3).
2. Release Tommy nut (1) and take off cover (2).
3. Carefully lift rotor (6), allow oil to drain and remove
from housing.
4. Holding the rotor (6) firmly, release rotor cover
nut (7).
5. Take off rotor cover (8).
6. Remove filter sleeve (10).
7. Measure thickness of oil residues on filter sleeve
(10).
8. If maximum layer thickness of oil residues exceeds
45 mm, shorten maintenance interval.
9. Disassemble rotor tube (11), conical disk (12)
and rotor base (14).
10. Wash rotor cover (8), rotor tube (11), conical disk
(12) and rotor base (14) with cleaner.
M015715/00E 06-08
• Wear protective clothing, gloves, and goggles / safety mask.
• Avoid contact with skin.
• Do not inhale oil vapor.
• Do not direct compressed-air jet at persons.
• Wear protective goggles / safety mask and ear protectors.
Part No.
F30027336
Part No.
Part No.
133
Qty.
1
Qty.
Qty.
© MTU