Master/Slave Configuration; Cad Drawing - ADJ COB Cannon Wash DW User Instructions

COB Cannon Wash DW
2. Press the SET UP button until "dr-X" is displayed. "X" represents
the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your
desired dimming curve.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote
Control). When this function is activated you can control the fixture
using the ADJ RFC. Please see the next page for ADJ RFC controls
and functions.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "rFXX" is displayed. "XX" repre-
sents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
ADJ Products, LLC - www.adj.com - COB Cannon Wash DW User Manual Page 14
Operating Instructions COB Cannon Wash DW
This function will allows you to link units together to run in a Master-
Slave mode. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of
the unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "SLAu" is dis-
played. Each "Slave" unit must be set to the same setting.
4. Connect the first "Slave" unit to the "Master." The "Slave" unit(s)
should now start following the "Master" unit.
COB Cannon Wash DW
427mm/16.81"
ADJ Products, LLC - www.adj.com - COB Cannon Wash DW User Manual Page 15
Master-Slave Configuration

CAD Drawing

315.5mm/12.42"