Toshiba MJ-1027 Service Manual page 141

4) Remove the three screws [6], and remove
the feed drive unit [7].
Caution:
Before re-attaching the removed feed drive
unit back on the finisher unit, loosen the move
gear stop screw [8] to relieve the tension, and
then fasten the screw after attaching the feed
drive unit.
The move gear attachment must be adjusted
also when removing and attaching the swing
unit.
If you forget to fasten the screw, the gear teeth
may disengage, resulting in defective feed.
3. Removing the Buffer Roller
Assembly
1) Remove the finisher controller PCB (see I-
C-1).
2) Remove the feed drive unit (see I-B-2).
3) Remove the screw [1], and remove the guide
support plate assembly [2] to slide out the
harness leads [3] towards the buffer roller
assembly side.
CHAPTER 4 MECHANICAL CONSTRUCTION
[7]
Figure 4-124
Figure 4-125
[1]
[2]
Figure 4-126
[6]
[6]
[6]
[8]
[3]
4-11