Toshiba MJ-1027 Service Manual page 138

CHAPTER 4 MECHANICAL CONSTRUCTION
11. Installing the Rear Sub-Support
1) Install the front sub-support [1]. Loosely
fasten the rear sub-support [2].
2) Install tray-2. Fasten the rear sub-support
so that the tray drive gear [3] is placed at
the center of the rack gear [4] of the rear
sub-support when tray-2 is at the upper limit
position and the lower limit position.
3) Move tray-2 by hand and check that it
moves smoothly.
12. Removing the Right Guide
Assembly
1) Remove the four screws [5] to take out the
latch unit [4]
2) Remove the rear cover (see I-A-2).
3) Open the front door assembly [1].
4) Remove the one screw [2], and remove the
right guide assembly [3].
4-8
[2]
Figure 4-117
[1]
Figure 4-118
[4]
[3]
[1]
[3]
[4]
[2]
[5]