Toshiba MJ-1027 Service Manual page 137

10. Removing the Grate-Shaped
Lower Guide
1) Remove the tray assembly.
2) Remove the five screws [1] (M4), and re-
move the front sub-support [2].
3) Remove the three screws [3] (M4).
4) Remove the three screws [4] (M3), and open
the grate-shaped lower guide [5] to the front.
Caution:
To remove a sub-support, remove the front
sub-support [2]. The rear sub-support [6] is
adjustable. If the rear sub-support [6] has
been removed, be sure to adjust the rear sub-
support screw to the marking at which it was
set prior to the removal, or adjust parallelism
referring to "11. Installing the Rear Sub-
Support."
4) Free the harness [9] from the harness stop
[8].
5) Disconnect the two connectors [10], and re-
move the grate-shaped lower guide [7].
CHAPTER 4 MECHANICAL CONSTRUCTION
[4]
[6]
Figure 4-115
[7]
Figure 4-116
[1]
[3]
[2]
[5]
[10]
[8]
[9]
4-7