IV. FIRMWARE UPDATING
A.
Finisher Unit
(1) Install the ROM to the download jig.
Make sure the direction and the type of ROM are correct.
[Download jig: K-PWA-DLM-320]
(2) Turn OFF the power of the equipment.
(3) Connect the finisher to the equipment after the finisher rear cover is removed.
(See chapter 4 I-A-2 for removing the rear cover.)
(4) Connect the download jig to the jig connecter on the finisher controller PCB.
Download jig
CHAPTER 5 MAINTENANCE AND INSPECTION
Identification for the ROM
Connector
installation direction
LED
ROM
5-3