Chapter 1 General Description; Features - Toshiba MJ-1027 Service Manual

I.

FEATURES

1. Accommodates large quantities of sheets
Normally, the finisher holds a stack of sheets 250 mm in height in its two bins (small-size
●
paper: equivalent to 2000 sheets)/140 mm in height (large-size paper: equivalent to 1000
sheets)
2. Has high paper transportation performance
The finisher is capable of handling papers between 60 and 256 gm/m
●
3. Offers a job offset function
The finisher has a job offset function for sorting non-stapled stacks of copies.
●
4. Offers four types of auto stapling
The finisher offers a choice of four stapling modes (1-point stapling at rear, diagonal sta-
●
pling at front, diagonal stapling at rear, 2-point stapling).
5. Uses a buffer roller
The use of a buffer roller enables the finisher to accept copies without interruption from the
●
host machine even during stapling or offset operation.
6. Has a saddle stitch function (Saddle Stitch Finisher MJ-1028)
The finisher can staple along the center of paper and fold it in two (up to 15 sheets).
●
7. Offers a punch function (option)
The use of the puncher unit enables the finisher to punch sheets for binders before they are
●
output. (The puncher unit is capable of handling papers between 60 g/m
2
256 g/m (141.4 lb. Index). It cannot handle special paper, postcards and transparencies.)
8. Insert function (option)
Enable the use of special type of paper and printed paper in addition to the staple sorting or
●
the hole punching mode (Available when the optional staple sorting and the hole punching
mode units are installed.) This paper is not run through fuser (heat).

CHAPTER 1 GENERAL DESCRIPTION

2
.
2
(16 lb. Bond) and
1-1