Saddle Stitcher Unit - Toshiba MJ-1027 Service Manual

B.

Saddle Stitcher Unit

(1) Install the ROM to the download jig.
Make sure the direction and the type of ROM are correct.
[Download jig: K-PWA-DLM-320]
(2) Turn OFF the power of the equipment.
(3) Remove the PCB cover on the saddle stitcher.
(See chapter 4 II-A-6 for removing the PCB cover.)
(4) Connect the download jig to the jig connecter on the saddle stitcher controller PCB to connect
the finisher with the equipment.
CHAPTER 5 MAINTENANCE AND INSPECTION
Identification for the ROM
Connector installation direction LED
ROM
Download jig
5-5