Master-Slave Configuration - ADJ COB CannOn Wash DW User Instructions

This is the 3 Channel DMX Mode.
• To run the 4 Channel Mode, press the MODE button until "Ch04" is displayed.
This is the 4 Channel DMX Mode.
• To run the 5 Channel Mode, press the MODE button until "Ch05" is displayed.
This is the 5 Channel DMX Mode.
• To run the 6 Channel Mode, press the MODE button until "Ch06" is displayed.
This is the 6 Channel DMX Mode.
4. Please see pages 7-8 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections to any
standard DMX controller.
Default Running Mode:
This is a default running mode. When this mode is activated all modes will return to their default settings.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.
DMX State:
This mode can be used as a precaution mode, that in case the DMX signal is lost, the operating mode chosen
in the setup is the running mode the fixture will go into when the DMX signal is lost. You can also set this as the
operating mode you would like the unit to return to when power is applied.
1. Plug the fixture in and press the MODE button until "d.XXX" is displayed. "XXX" represents the current
displayed DMX address.
2. Press the SET UP button so that "nodn" is displayed. Use the UP and DOWN buttons to scroll through the
DMX states.
• "bLAC" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into stand by mode.
• "LASt" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX set up. If power
is applied and this mode is set, the unit will automatically go into the last DMX set up.
• "ProG" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into Auto Run mode.
3. Use the UP and DOWN buttons to find your desired DMX state and press SET UP to confirm and exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See page 14 for the dimming curves chart.
1.Plug the fixture in and press the MODE button until "d.XXX" is displayed. "XXX" represents the current
displayed DMX address.
2. Press the SET UP button until "dr-X" is displayed. "X" represents the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your desired dimming curve.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote Control). When this function is activated
you can control the fixture using the ADJ RFC. Please see the next page for ADJ RFC controls and functions.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "rFXX" is displayed. "XX" represents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).

MASTER-SLAVE CONFIGURATION

This function will allows you to link units together to run in a Master-Slave mode. In a Master-Slave set up one
unit will act as the controlling unit and the others will react to the controlling units built-in programs. Any unit can
act as a Master or as a Slave however, only one unit can be programmed to act as the "Master."
ADJ Products, LLC - www.adj.com COB Cannon Wash DW User Manual Page 10