Set The Boot Device - Cisco C880 M4 Configuration Manual

4.
Figure 93.
Note that after you change the Topology Selection or Force Link Speed settings and then select Discard Changes,
if you are returned to the screen for changing settings, the changes to the 16-Gbps Fibre Channel card settings
have been discarded. However, you may still see the changed settings displayed by the utility. In this case, select
the 16-Gbps Fibre Channel card again from the menu as described earlier in the section "Start the HBA Setup
Utility and Select the HBA" before proceeding.

Set the Boot Device

Now set the boot device.
1.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Commit the changes. After the completion of the Commit Changes process, you are returned to the Port
001:Emulex LPe16002B-M6-F16Gb 2-port PCIe Fiber Chann screen (Figure 93).
Topology and Link Speed Change Confirmation (2)
On the Port 001:Emulex LPe16002B-M6-F 16Gb 2-port PCIe Fiber Chann screen, select Scan for Fiber
Devices and then press the Enter key (Figure 94).
Page 87 of 146