Cisco C880 M4 Configuration Manual page 117

Figure 135. BIOS Device Settings (11)
Note:
the Fibre Channel switch may be incorrect. Confirm these settings again.
10. Press the Esc key. The message to save the setting is displayed. Then return to the Device Manager.
11. For a multipath configuration, configure the settings described earlier in the sections from "Start the HBA
12. After all the settings are configured, select Exit Emulex HBA Configuration Utility and then press the Enter
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
If the expected Fibre Channel device is not displayed, the SAN storage or physical connection settings of
Setup Utility" to "Set the Link Speed and Topology" for all the HBAs connected to the SAN storage unit
LUN from which the system is started. Also, after installing the OS and multipath driver, perform the
operation described in the section "Set the Boot Device" for all the HBAs used to start the system.
key to return to the Device Manager menu.
Page 117 of 146