16-Gbps Fibre Channel Card Settings: Traditional Bios Driver Version 6.02X6 Or Later; Configure The Hba Setup Utility - Cisco C880 M4 Configuration Manual
With sap hana tailored datacenter integration
Hide thumbs
Also See for C880 M4:
- Service manual (132 pages) ,
- Operating manual (58 pages) ,
- Service supplement manual (27 pages)
Table of Contents
Advertisement
16-Gbps Fibre Channel Card Settings: Traditional BIOS Driver Version 6.02x6 or Later
This section describes the procedure for setting traditional BIOS Driver Version 6.02x6 or later.
Configure the HBA Setup Utility
Start by configuring the HBA Setup Utility.
1.
Figure 112. Starting Traditional BIOS Setup
2.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Start the system, and when the screen shown in Figure 108 appears, press Alt+E or Ctrl+E.
Start the Emulex LightPulse BIOS Utility. Fibre Channel ports of the Fibre Channel card appear on the
HBA list screen. Select a Fibre Channel port to set up and press the Enter key (Figure 113).
Page 101 of 146
Advertisement
Table of Contents
