Set The Link Speed And Topology - Cisco C880 M4 Configuration Manual
With sap hana tailored datacenter integration
Hide thumbs
Also See for C880 M4:
- Service manual (132 pages) ,
- Operating manual (58 pages) ,
- Service supplement manual (27 pages)
Table of Contents
Advertisement
Figure 116. Enable/Disable Boot from SAN Setup Screen (2)
Note:
Set the Link Speed and Topology
This section describes how to set the speed and topology.
Set the Topology
Follow these steps to set the topology:
1.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Confirm that the boot BIOS is enabled.
In the main menu, select Configure Advanced Adapter Parameters and then press the Enter key (Figure
117).
Page 104 of 146
Advertisement
Table of Contents
