Advertisement
8
Note: The curved horns are for
the ailerons, and the triangle
shaped horns are for the flaps.
Mix up some epoxy, and use a
tool/stick to pace into the holes
of the control surface.
Wipe some epoxy onto the
sanded tab area of the horn,
and insert into control surface.
Clean any excess glue with
denatured alcohol (methylated
spirits).
Repeat for all flap and aileron
horns.
Using the hardware that came
with your servo, mount the
servos to the removable servo
access doors as shown.
Note: We recommend screwing
the servo to the mount and
then removing it to apply a drop
of thin CA to the servo screw
holes to make them stronger.
Advertisement
