Advertisement
14
Slide the stabilizer into place, and
use a rule or tape measure to
make sure it is centered.
To make sure that the stabilizer is
straight,
measure
from
corner of the stabilizer to the rear
of the canopy bay. Do this on
each side and adjust the angle of
the stabilizer until even.
Measure this more than twice,
including the step above of
measuring it is centered. Moving
the stabilizer after it is glued is
not recommended.
Using thin CA, add a run of glue
along each side of the top of the
stabilizer.
Allow the top to dry before doing
the same to the bottom.
Note: It is recommended to take
your time with this step and allow
the glue to dry before doing the
bottom. Taking your time helps
prevent the CA from running.
Add pins to the center of the
hinges
and
insert
stabilizer. Then slide the elevator
onto the hinges.
the
into
the
Advertisement
