Operation
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Auto Programs
Auto programs allow for dynamic blinder effects without a DMX controller.
1. Go to the Auto Show main level.
2. Select the desired auto program (Auto 1–4).
3. Select the desired speed (1–100).
The auto programs cannot be edited.
Static Mode
The Static mode allows for permanent dimmer and strobe presets without a DMX controller.
1. Go to the Static main level.
2. Select Dimmer or Strobe.
3. Set the desired output value (0–255)
Dimmer Profiles
This setting determines how fast the output of the WELL Gobo changes when you modify the output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting product.
1. Go to the Dimmer Mode main level.
2. Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, DIM1 being the fastest.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the WELL Gobo.
1. Go to the LED Frequency main level.
2. Select PWM Frequency (25Hz, 600Hz, 1200Hz, 2000Hz, 4000Hz, or 6000Hz).
Back Light
This setting allows for selection of the amount of time the backlight on the WELL Gobo's display stays on
after the last button is pressed on the control panel.
1. Go to the Back Light main level.
2. Select 10S (10 seconds), 30S (30 seconds), 2Min (2 minutes), or Always On (remains on).
Control Panel Lock
This setting locks or unlock the display control panel.
1. Go to the Key Lock main level.
2. Select On (locks control panel) or Off (control panel stays unlocked).
When the control panel lock is activated, the product will prompt for the passcode
to access the menu. Enter the passcode by pressing:
<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1. Go to the Information main level.
2. Select Fixture Hours or Version.
Factory Reset
This option restores the WELL Gobo to factory default settings.
1. Go to the Reset Factory main level.
2. Select No or Yes.
WELL Gobo User Manual Rev. 1
Page 11 of 17