Table of Contents
Advertisement
O
PERATION
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Static Mode
The Static mode allows for an unchanging color without a DMX controller.
Color Temperature
To select a color temperature, do the following:
1.
Go to the Static main level.
2.
Select Color Temperature.
3.
Select the desired color temperature (see
4.
Select the desired output level (0–255).
Manual Color Mixer
To do color mixing without a DMX controller, follow the instructions below:
1.
Go to the Static main level.
2.
Select Manual Color Mixer.
3.
Select the color to edit (Red, Orange, Green, Royal Blue, Blue, or Lime Green).
4.
Select the desired output level for that color (0–255).
5.
Repeat steps 3 and 4 until product outputs as desired.
Red Shift
The Red Shift function causes the amber LEDs to imitate the appearance of a halogen lamp when dimming.
To adjust the Red Shift function, do the following:
1.
Go to the Red Shift main level.
2.
Select On or Off.
Master/Slave
The Master/Slave mode allows a group of Ovation P-56VW products (the slaves) to simultaneously
duplicate the output of another Ovation P-56VW (the master) without a DMX controller.
To set each of the slaves:
1.
Go to the Master/Slave main level
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level
2.
Select Master.
3.
Select a static setting.
•
The master is the one that runs a program whether in Auto or Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Go to the Dimmer Curve main level.
2.
Select the desired option (Linear, Square, I Squa, or SCurve).
Dimmer Profiles
This setting determines how fast the output of the Ovation P-56VW changes when the output value is
modified. It provides four different options to simulate the dimming curve of an incandescent lighting product.
To select a specific dimmer profile, do the following:
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, Dimmer 1 being the fastest.
Ovation P-56VW User Manual Rev. 4
Color
Temperature).
Page 13 of 23
Advertisement
Table of Contents
