Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Focus Mode
Focus mode allows for focusing of the Ovation E-910FC IP without changing any menu settings.
1.
Press and hold <ENTER> for 3 seconds. The output intensity will increase to 100%.
2.
Press <MENU> to exit focus mode and restore the settings.
Virtual Color Wheel
The Ovation E-910FC IP offers more than 30 premixed colors based on gel colors. See the
Wheel
section for details on specific values. To select a gel color, do the following:
1.
Go to the Virtual Color Wheel main level.
2.
Select Virtual Color Wheel.
3.
Select the desired gel color (see
4.
Select the desired output level (0–255).
Color Temperature
The Color Temperature mode offer preset white color temperatures that emulate a tungsten lamp at the
specified color temperature. See the
color temperature, do the following:
1.
Go to the Virtual Color Wheel main level.
2.
Select Color Temperature.
3.
Select the desired color temperature (see
4.
Select the desired output level (0–255).
Manual Color Mixer
The Manual Color Mixer mode allows for permanent RGBAL color mixing without a DMX controller.
1.
Go to the Virtual Color Wheel main level.
2.
Select Manual Color Mixer.
3.
Select the color to edit (Red, Green, Blue, Amber, or Lime).
4.
Select the desired output level for that color (0–255).
5.
Repeat steps 3 and 4 until product outputs as desired.
Auto Programs
Auto programs allow for dynamic blinder effects without a DMX controller.
1.
Go to the Auto Show main level
2.
Select the desired auto program (Auto 1–5).
3.
Select the desired speed (1–100).
The auto programs cannot be edited.
Red Shift
The Red Shift function causes the amber LEDs to imitate the appearance of a halogen lamp when dimming.
1.
Go to the Red Shift main level.
2.
Select On or Off.
Gobo Rotator
(for use with Ovation GR-1 IP, sold separately)
The gobo rotator mode controls the Ovation GR-1 IP rotation speed.
1.
Go to the Gobo Rotator main level.
2.
Select the desired value (0–255).
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Go to the Dimmer Curve main level.
2.
Select the desired option (Linear, Square, I Squa, or SCurve).
3.
Press <ENTER>.
Page 18 of 31
Virtual Color Wheel
Color Temperature
section for details on specified values. To select a
Virtual Color
Chart).
Wheel).
Ovation E-910FC IP User Manual Rev. 4
O
PERATION
Virtual Color