RADVision SCOPIA XT100 Series User Manual page 32

Procedure
Step 1
Connect your computer to the Codec Unit:
1.
2.
3.
Note:
Step 2
Connect the computer audio to the Codec Unit.
•
•
Step 3
Press
RADVISION | User Guide for SCOPIA XT1000 Series Version 2.0
•
For computers and laptops with a DVI out connector, connect the DVI cable to the DVI-I socket
of the Codec Unit and connect the other end of the cable to the computer.
Figure 3-7 Connecting a computer featuring a DVI out connection
•
For computers with a VGA ouput connector, use a DVI to VGA adapter.
Connect the DVI-VGA adapter to the DVI-IN socket of the Codec Unit.
Connect a VGA cable to the adapter. This cable does not ship with the system.
Connect the VGA cable to the PC/Laptop VGA out socket.
When the computer VGA output is connected to the Codec Unit DVI input using an
adapter, the Codec Unit supports a resolution of 1440 x 900 maximum.
Since audio input is not included in the DVI-I port to Codec Unit connection, establish a
separate audio connection from the computer's audio output port into the S/PDIF audio
input port of the Codec Unit.
If the computer does not support digital audio, use an external analog-to-digital converter.
See the SCOPIA XT1000 Installation Guide for information on this setup.
on the Remote Control Unit to share a presentation before or during a call.
'Managing Calls' | 29