Figure 3-2 on page 25
side by side and at the same size.
You can use PIP and/or PaP views if your system administrator has configured them in your Codec
Unit.
PIP configuration also includes these setups:
During the call, you can change your monitor's default layout to facilitate your work:
System menus automatically disappear from the display after a few seconds in a call. You can also
remove them manually by pressing
Note:
When there is no call, you can reset the monitor to the default configuration by pressing
0 on the Remote Control Unit.
RADVISION | User Guide for SCOPIA XT1000 Series Version 2.0
Figure 3-1
depicts a PaP (Picture and Picture) view in which two images are presented
Figure 3-2
•
Starting position of the PIP view in the display (top left, top right, bottom left, bottom right)
•
Direction in which the PIP view changes position (clockwise, counterclockwise, or no change
of position).
•
To change the position of a PIP view on the monitor, show a PaP view, or display a full screen
view of one of the images, press
•
When you are in PIP view, you can change its content by pressing
•
When you are in PaP view, you can change its content by pressing
•
When you are in full presentation view, you can change its content by pressing
Showing the display in PIP view
Showing the display in PaP view
repeatedly.
. To bring back the system menus, press
repeatedly.
repeatedly.
repeatedly.
again.
then
'Managing Calls' | 25