Additional Dual Access Limitations - Ricoh 5510L Service Manual

SYSTEM FEATURES
With dual access, more than one job can be in progress at the same time. However,
some types of job take up more machine resources, and this limits the jobs that
can be done at the same time. Each type of job takes up a certain number of
resource 'points'. The table below lists the 'points' for each type of job.
Job Types
Save doc. in memory
SAF output
SAF output (JBIG)
Printing
Copying
Auto journal print
Auto journal print
(JBIG)
Immediate send
Memory send
Immediate receive
Memory receive
Report send
Mail send
Mail receive
IP FAX send
IP FAX receive
JBIG
Non-ECM RX
LAN PC Fax
Off Hook
• The maximum number of points that can be taken up by jobs in progress at the
same time is 24.
For example, the following two jobs cannot be done at the same time, because
the total number of points comes to 27:
Memory Tx (600 dpi, JBIG)
Memory Tx (600 dpi, MMR)

Additional Dual Access Limitations

Here is a list of other restrictions on resources and job count management:
• Up to two transmissions can be done at the same time (including mail sending)
• There can be up to two G4 jobs at the same time
• There can be up to 5 LAN PC Fax jobs at the same time
• Mail send and IP fax (also called 'real time internet fax') send are limited to 1 job
each
• JBIG is possible with Main G3 + Option G3.
(However, it is not possible with Main G3 + G4 (IG3).
• ISDN G3 requires either the Main G3 or Optional G3 modem, so other ISDN kit
resources can be used for G4 TX/RX.
• When selection of the G3 line is automatic, the priority is IG3 > PSTN2 > PSTN1.
POINTS
The number of points taken by a job
0
depends on the resolution:
0 200 dpi: Points x 1
4 400 dpi: Points x 2
0 600 dpi: Points x 3
0
0
4
1
4
2
0
4
4
2
4
2
1
1
0
6
(4+1) x 3 = 15 points
6-64
(4) x 3 = 12 points
Total: 27 points
14 June, 2002