eka EKF 464 TC Original Operating And Instruction Manual page 6

TECNOEKA Srl ___________________________________________________________ operating and instruction manual
3.3 Unpacking the appliance
Remove packaging before installation. It consists of a wooden pallet supporting the appliance and
a cardboard casing protecting it. Ensure the appliance has not undergone any damage during
transport; otherwise immediately alert your dealer and/or carrier.
3.4 Removal of the protecting film
Before using the appliance accurately remove the special film protecting the stainless steel
components, avoiding to leave glue residues on the surfaces; if required, immediately remove
them using an appropriate solvent of non flammable type.
3.5 Disposal of packaging
The packaging must be disposed of in strict compliance with the regulations in force in the place
of installation of the appliance. The various materials (wood-paper-cardboard-nylon-metal staples)
the packaging consists of must be suitably separated and delivered to the suitable collection
centres. In any case adhere to environmental protection regulations.
3.6 Placement
Check the place of installation ensuring transit areas (any doors and corridors) are sufficiently wide
(the dimensions of the appliance without pallet are shown in Fig.1).
The appliance must be installed in a well-aerated room with permanent vents.
The maximum working height, referred to the highest surface level, must be 1.6 metres from the
floor. After installing the appliance apply the suitable adhesive symbol (supplied) at a height of 1.6
metres. To assure accessibility and air circulation around the appliance, leave at least 50cm of
space between the left side and the wall (or other appliance), and at least 10 cm between the
back and the wall and between the right side and the wall (see Fig.1). It is strictly forbidden to
obstruct, even partially, the forced aeration vents on the left side, even for short periods of time.
Failure to comply with this explicit prohibition shall void any liability from the appliance's
manufacturer and immediately forfeit any warranty rights on the same, since its constructive
conformity has been deliberately impaired. For the same reason, do not place any appliances that
might produce heat sources and/or spray hot liquids (fryers) near the left side.
Should the appliance be installed near walls, shelves, tops and the like, these must be of the non
flammable or heat-insensitive type; otherwise, they must be protected by adequate fire retardant
coating. In this connection it is indispensable to act in compliance with the fire prevention
regulations in force.
Cooking produces hot smoke and smells which are expelled from the suitable vent device at the
top of the appliance. It is recommended to place the appliance under an extraction hood or to use
the suitable TECNOEKA hoods, in order to convey the smoke to the outside.
3.6.1 Table top oven placement
The appliance must be placed in a perfectly horizontal position on a table or similar support; never
on the floor.
For safety reasons it is recommended to use the support produced by the manufacturer; otherwise
the weight of the appliance must be taken into account. The appliance is unsuitable for recessing.
Warning
In the event the appliance is positioned on a wheeled table/support, ensure the permissible
movement does not damage electrical wires, water pipes, drain pipes or anything else.
3.7 Electrical connection
Connection to the power mains must be performed according to regulations in force. Before
performing the connection ensure that:
- the voltage and frequency of the power supply system match with
the specifications on the "technical data" plate affixed on the side of the appliance;
page 6 _____________________________________________________________________________________________